Hair extension application

The Bio Tape Set comes ready and fully prepared for application.
Before applying the extensions, wash your hair twice with a deep cleansing shampoo and dry it very thoroughly.

1. Create a parting
Make a straight parting from ear to ear. Try to keep it as even as possible and secure any small strands with clips.

2. Heat the bio tape
Take the longest bio tape and warm it up with a straightener using short, tapping motions. Hold it for a few seconds.

3. Attach under the parting
Remove the white protective film from one side of the bio tape and stick it just under the parting, about 1 mm from the scalp. To make it easier, find the center of the tape and first press one half, then the other. Then press the bio tape firmly to the head.

4. Cover the bio tape with your own hair
Remove the second, upper white protective film. Section off about 2–3 cm of your own hair, gently place it over the bio tape and stick it onto the adhesive part, pressing it down. Do this gradually, from one end to the other. Once again, press the entire bio tape firmly to the head.

Applying side bio tapes
If you want the hair to fall more towards your face, place the side bio tape at an angle, not parallel to the parting: the back part of the side tape should sit slightly lower, while the part closer to the face should be higher.

If your set includes 4 bio tapes, you will also need to attach an additional occipital tape. Follow the same steps as in the instructions. Apply the second occipital tape as high as possible at the nape.